2026-11-08 · Marcus Thibodeaux
Mold Removal Cost in Shreveport: A Room-by-Room Price Guide
Nobody budgets for mold. It arrives as a smell, a stain, or a line in an inspection report, and the first question is always the same: what is this going to cost? The honest answer is that mold remediation is priced by the contaminated area and by how hard that area is to reach, not by the size of your house. A 1,900 square foot home with 60 square feet of affected drywall is a 60 square foot job.
Here is what the numbers actually look like in Shreveport, what drives them, and the two line items that catch most homeowners out.
The Per-Square-Foot Baseline
Nationally, professional mold remediation runs $10 to $25 per square foot of contaminated area, with most homeowners spending between $1,200 and $3,800 and a national average around $2,300 to $2,500. Shreveport generally sits at the lower-to-middle end of that range, since regional labor rates are below the coastal metros those averages include.
That rate moves with difficulty rather than area:
- Surface work on non-porous material: $10–$25 per sq ft
- Work requiring drywall demolition: $15–$30 per sq ft
- Work exposing subfloor or framing: $25–$40 per sq ft
- Crawl space work including encapsulation: $7–$15 per sq ft
- Attic remediation: $9–$20 per sq ft
Most contractors also carry a minimum project charge, commonly $500 to $1,500, simply to mobilize containment and equipment. That is why a very small job rarely costs proportionally less than a moderate one.
Cost by Location in the House
Where the mold is matters more than how much of it there is. These are the ranges to expect:
| Location | Typical cost | |---|---| | Bathroom (surface: grout, caulk, ceiling) | $300–$900 | | Bathroom (behind tile or under the tub) | $1,500–$5,000 | | Crawl space (removal only) | $500–$2,500 | | Crawl space (with full encapsulation) | $3,000–$7,000 | | Attic | $1,000–$4,000, to $7,000 severe | | Basement | $500–$3,000 | | Walls and drywall | $1,000–$20,000 | | HVAC and ductwork | $1,500–$6,000 | | Whole house | $10,000–$30,000 |
The spread on walls and drywall looks absurd until you understand it: a single patch of affected drywall in an accessible room is cheap, and mold that has travelled through the wall cavities of several rooms is a reconstruction project.
What Inspection and Testing Cost
These are separate from remediation and priced independently:
- Visual mold inspection: $150–$300 for a typical single-story Shreveport home
- Air sampling package: $250–$450 for three samples plus lab report
- Full inspection with moisture mapping: $350–$600 including crawl space and attic
- Post-remediation clearance testing: $200–$650 depending on the number of areas
Lab results generally return in two to three business days.
One thing specific to Louisiana is worth knowing before you pay for anything. Under La. R.S. 37:2187, no licensee may perform both mold assessment and mold remediation on the same property, and no person may hold an ownership interest in both entities working that property. Your remediation contractor is legally barred from certifying its own clearance test. If someone offers you a package deal covering both, that package has a compliance problem.
Separately, the Louisiana State Licensing Board for Contractors requires a Mold Remediation license for any remediation project valued at $7,500 or more, which requires twenty-four hours of board-approved training plus workers' compensation and liability coverage. Verifying the license is free and takes a minute.
The Two Line Items Nobody Budgets For
First: repairing the water source. This is the single biggest swing in the total, and it is almost never included in the remediation quote. Mold is a symptom. The roof repair behind an attic job runs $350 to $1,250 for a patch and far more for a replacement. The plumbing repair behind a bathroom job is usually minor, but the tile and subfloor rebuild around it is not. Crawl space drainage and grading correction is its own scope. If the quote you are holding does not name the moisture source and say who is fixing it, the price is incomplete.
Second: reconstruction. Remediation gets the contaminated material out and the structure dry. It does not put the drywall, tile, trim, insulation or flooring back. Budget for rebuild as a separate line, and clarify in writing which party is doing it.
Why Shreveport Costs Behave the Way They Do
Three local factors shape the numbers here.
Pier-and-beam construction over damp soil. Much of the older housing stock in Highland, Allendale, Queensborough and Cedar Grove sits on brick piers above soil that stays wet through Caddo Parish's mild winters. That makes crawl space work the most common job in the city, and it makes encapsulation — which costs more upfront — the only version of the work that does not recur. Paying $1,500 three times is worse value than paying $4,500 once.
No dry season. Most of the country gets a stretch of low humidity that resets moisture levels. Shreveport does not, which is why a remediation that leaves the moisture source in place fails here faster than it would in a dry climate.
Access, not area. Attic and crawl space work is frequently priced by labor hours rather than square footage, because the constraint is the 22-inch hatch and the 120-degree August attic, not the size of the stain.
How to Read a Mold Quote
A quote worth comparing names five things. The contaminated square footage and how it was measured. The containment method, including whether negative air and HEPA filtration are used. Which materials are being removed versus cleaned. The moisture source and who is correcting it. And the clearance method, including who runs it — which, in Louisiana, has to be someone other than the remediation contractor.
If two quotes differ by thousands, the difference is almost always in those five items rather than in the hourly rate. Get at least three itemized bids, verify the license, and confirm the moisture repair is scoped by someone before you sign.
Figures in this guide are typical ranges for budgeting and reflect 2026 national and regional data. An exact price requires an on-site assessment of your property.